# Contract Costs Under ASC 606, Explained: When Sales Commissions Become an Asset

Your best rep just closed a three-year deal worth 180,000 dollars and earned a 9,000 dollar commission. Your instinct is to expense the 9,000 dollars this month — cash went out the door, so it must be this month's cost. Under U.S. GAAP, that instinct overstates this month's expense and understates the next thirty-five months of it. The commission bought you three years of revenue, so the matching principle says its cost should be spread across the same three years. That is exactly what ASC 340-40, the contract-cost companion to ASC 606, requires: the incremental costs of winning a contract and certain costs of fulfilling it go on the balance sheet as an asset when you expect to recover them, then amortize as you deliver. This guide walks through the two cost buckets, the tests each one must pass, how amortization really works, the one-year shortcut most small businesses rely on, and the impairment trap that writes the asset back off.

## The Two Buckets: Costs to Obtain vs. Costs to Fulfill

Every contract cost falls into one of two buckets, and each bucket has its own capitalization test:

| | Costs to obtain | Costs to fulfill |
| --- | --- | --- |
| Question asked | What did winning this deal cost? | What will performing this deal cost? |
| Classic example | Sales commissions | Setup labor, onboarding work |
| Test | Incremental and recoverable | Three-part test, all must pass |
| Shortcut | One-year practical expedient | No expedient — run the full test |

The distinction matters because costs that fail their bucket's test are expensed immediately. There is no third bucket, no "close enough" category. A cost either meets its test and becomes an asset, or it hits the income statement now.

One more boundary before the details: the fulfill bucket is a backstop, not the first stop. If another standard already governs the cost, that standard wins. Inventory goes through ASC 330, internal-use software through ASC 350-40, long-lived assets through ASC 360, and financial instruments through their own guidance. Only costs with no other home reach the ASC 340-40 fulfill test.

## Costs to Obtain: The Incremental Test

A cost to obtain a contract is capitalized when it is incremental and recoverable. Incremental means you would not have incurred it if you had not won this specific contract. Recoverable means you expect to get it back through the contract's margin. Both conditions must hold.

Sales commissions are the textbook example. A 5 percent commission paid only when a deal closes is incremental by definition — no signature, no payout. Finder's fees, broker fees paid on close, and success-based referral bonuses work the same way. What they share is contingency on winning: the cost exists because this contract exists.

### What Fails the Incremental Test

Most of what sales actually costs does not qualify, because you would have spent it anyway:

- **Base salaries and benefits** for sales staff. The rep gets paid whether your pipeline closes or not.
- **Travel, meals, and entertainment** tied to pitching. You incur them chasing deals you lose, too.
- **Proposal and bid costs.** Writing the proposal happens before anyone knows the outcome.
- **Advertising and marketing.** General demand generation is not tied to any specific contract.
- **Overhead allocations.** A share of the sales manager's salary or the CRM subscription is not incremental to one deal.

The test is always the same counterfactual: if this exact contract had fallen through at the last minute, would you still have spent this money? If yes, expense it now.

The recoverability half of the test rarely bites on its own — a commission on a profitable contract is plainly recoverable — but it matters when margins are thin or the customer's credit is shaky. A large commission on a deal you expect to lose money on cannot be capitalized, because there is nothing to recover it from.

## Costs to Fulfill: The Three-Part Test

Costs to fulfill a contract are capitalized only when all three of the following hold at once. Fail any one and the cost is expensed:

1. **Direct relationship.** The costs relate directly to a contract, or to a specifically identifiable anticipated contract — for example, design work for a renewal you are negotiating, or mobilization for a signed statement of work whose start date is set. Vague "we hope this leads to business" spending does not count.
2. **Future benefit.** The costs generate or enhance a resource you will use to satisfy performance obligations in the future. Setup labor that builds the customer's environment, custom configuration, and data migration all create something you draw on as you deliver.
3. **Recoverability.** You expect to recover the costs through the contract price.

Costs that typically pass include direct labor for employees delivering the promised services, direct materials and supplies consumed in delivery, allocated costs that relate directly to the contract such as supervision and equipment depreciation, amounts explicitly chargeable to the customer under the contract terms, and subcontractor payments incurred only because you entered the contract.

Just as important is what the standard tells you to expense outright: general and administrative costs, wasted materials and labor that the contract price never contemplated, costs related to performance you already completed, and any cost you cannot associate with a specific performance obligation. Pre-contract mobilization for a deal that may never sign, rework caused by your own errors, and idle capacity all hit the income statement immediately.

## Amortization: Match the Transfer, Not Just the Term

A capitalized contract cost is amortized on a systematic basis consistent with the transfer of the goods or services the asset relates to. In plain terms: recognize the cost the way you recognize the revenue. Straight-line monthly amortization over the contract term is the common answer for a subscription or service contract delivered evenly, but the method must follow the delivery pattern — if you deliver half the value up front, half the asset amortizes up front.

The amortization period is where businesses most often go wrong, because it is the period of benefit, not necessarily the contract term. Consider a two-year contract with an expected renewal. If the renewal commission is commensurate with the initial commission — the rep gets paid again at a similar rate for the renewal — then the initial commission bought only the initial term, and you amortize over two years. But if renewals pay little or no commission, the initial commission effectively bought the initial term plus the expected renewals, and the amortization period stretches to cover them. A large upfront commission with token renewal payouts can easily produce a four- or five-year amortization period on a two-year contract.

The mechanics are simple once the period is set. A 6,000 dollar commission capitalized on a 24-month contract amortizes at 250 dollars a month:

```beancount
2026-01-01 open Assets:Contract-Costs
2026-01-01 open Assets:Cash
2026-01-01 open Expenses:Commissions

2026-03-01 * "Rep payout" "Capitalize 6000 commission on 24-month contract"
  Assets:Contract-Costs  6000.00 USD
  Assets:Cash  -6000.00 USD

2026-03-31 * "Month-end" "Amortize commission, month 1 of 24"
  Expenses:Commissions  250.00 USD
  Assets:Contract-Costs  -250.00 USD
```

If your estimate of the timing changes — the customer renews early, churns, or upgrades mid-term — you adjust the amortization prospectively as a change in estimate, not with a catch-up restatement. And tracking each capitalized commission in its own subaccount, such as Assets:Contract-Costs:Acme-2026, keeps every amortization schedule tied to its contract at a glance. The [Beancount documentation](/docs/) covers subaccount design for exactly this kind of tracking.

## The One-Year Practical Expedient — and Its Trap

ASC 340-40-25-4 offers a shortcut: you may expense incremental obtain costs as incurred when the amortization period of the resulting asset would be one year or less. For businesses selling monthly or annual contracts with no meaningful renewal benefit, this expedient removes the whole capitalization exercise — commissions hit the income statement when paid, and no asset is ever recorded. Apply it consistently as a policy choice, and document that choice for your auditors.

The trap is testing the wrong period. The one-year test runs on the amortization period, not the contract term — and as the last section showed, those two can differ. A one-year contract with strong expected renewals and a fat upfront commission has an amortization period longer than one year, which means the expedient is unavailable and the commission must be capitalized. The businesses that get this wrong almost always make the same error: they see "12-month contract" and expense everything, never asking what the commission really bought. Before you expense, ask whether renewal commissions are commensurate. If renewals pay nothing close to the initial rate, measure the expected customer life and capitalize accordingly.

Note the asymmetry: the expedient covers costs to obtain only. There is no one-year shortcut for fulfillment costs — those always run the full three-part test, whatever the contract length.

## Impairment: When the Asset Is No Longer Recoverable

Capitalized contract costs are tested for impairment whenever events suggest the carrying amount may not be recoverable, and the test itself is a margin check. Compare the asset's carrying amount against the remaining consideration you expect to receive under the contract, minus the remaining costs of fulfilling it that you have not yet recognized. If the carrying amount exceeds that remaining margin, write down the excess to profit or loss immediately.

Customer distress is the classic trigger: the client stops paying, files for bankruptcy, or cancels early, and the remaining consideration collapses below what you capitalized. Scope creep is the quieter one — fulfillment costs balloon past the contract price, the remaining margin goes negative, and the asset is impaired even though the customer is perfectly happy.

Two ordering rules complete the picture. First, test other related assets before the contract-cost asset: recognize impairment on receivables and contract assets under their own guidance first, then test what is left. Second, and unlike IFRS, U.S. GAAP prohibits reversing the write-down. ASC 340-40-35-6 states flatly that an entity shall not recognize a reversal of a previously recognized impairment loss — if the customer recovers and the contract turns profitable again, the written-down amount stays written down.

## A Month-End Checklist for Small Businesses

Putting this into practice takes a short routine, not a new department:

1. **List every commission and success fee paid this month.** For each one, run the incremental counterfactual: would you have spent it if that exact deal had died? Salaries, travel, and proposal costs never make the list.
2. **Check your expedient policy.** If every deal amortizes within a year — short contracts, commensurate renewal commissions — expense and move on. The moment a big upfront commission buys multi-year benefit, that deal leaves the expedient behind.
3. **Capitalize what remains and schedule it.** Record the asset, set the amortization period to the expected period of benefit including renewals, and book the monthly charge with the same rhythm as the revenue.
4. **Run the fulfill test on setup costs.** Onboarding labor, migration work, and custom configuration get the three-part test: direct, future-benefit, recoverable. Everything else is this month's expense.
5. **Scan for impairment indicators.** Any customer in distress, any contract running underwater, any early cancellation — run the margin test and write down what fails.
6. **Track the book-tax difference.** For tax purposes, commissions are generally deductible when paid or incurred, while your books now spread them over years. That timing gap is a deferred tax asset your CPA needs on the provision — flag it rather than letting it surface at year-end.

Start with this month's commission run: pull the payout list, mark each line incremental or not, and confirm your one-year expedient still fits every deal on it. That single review catches the two errors that create nearly all contract-cost restatements — expensing commissions that should have been capitalized, and capitalizing costs that were never incremental in the first place.
